Archive of the former Yahoo!Groups mailing list: Homebrew PCBs
Subject: Re: Newbie asks: 0.064" stock in GBC 9" Personal Laminator?
From: "schabtach" <adam@...>
Date: 2006-11-05
Following up on my own question, I've successfully fed 0.064" stock
through a GBC 9" laminator. The caveat is that the paper used for
transferring the toner can't be too thick. One layer of Epson Glossy
Photo paper, which is pretty thick, works fine. Two layers of magazine
paper (I was trying to make a sandwich to transfer both sides at once)
also works. Two layers of the thick Epson paper does not work, and I
ended up having to use pliers to remove the board from the laminator.
--Adam