Polyesters will not bond metal (not for long or very well anyway).
You do need epoxy or a ca type adhesive. Epoxy should be the longer
cure types not the 5 minute stuff. Scuff the copper with some
220 or 180 grit wet sandpaper and wipe down with acetone to remove
the gunk. You can also use those green plastic brillo pads found in
the kitchen, just make sure they are the soap free kind.
Copper, epoxy and frp boards bond pretty nice.
Dave
> >
> > Epoxy will certainly stick if you oxidize or maybe pre-etch the copper.
> >
> > Neat idea with the powder coat - what resolution would you get with it?
>
> Epoxy resin in the fiberglass or an epoxy adhesive ?
>
>
> I just posted another message that the copper would not stick well
> using the resin as the adhesive. I did infact try it twice one time by
> blasting and once as you mentioned, but not in the terms as an
> oxidzer, but more or less to roughen the surface. I thought that maybe
> I was somehow contaminating the surface by the abrasive blast.
>
> BTW I checked.. the resing in my fiberglass kit is a polyester, not
> epoxy. Do you think the epoxy resin would make much differance ?
>
> As far as the resolution goes.. it dependes on how steady you are at
> getting it from the printer to the kitchen to apply the powder ;)
>
> I also found the sifting the powder through and old bandanna doesnt
> disturb the ink as much and gives a much finer line.. But all in all I
> say it is no better or worse than any toner transfer method I have tried
>
> Bill
>
>
>
>
>
>
> Be sure to visit the group home and check for new Links, Files,
> and Photos:
> http://groups.yahoo.com/group/Homebrew_PCBs
>
> If Files or Photos are running short of space, post them here:
> http://groups.yahoo.com/group/Homebrew_PCBs_Archives/
> Yahoo! Groups Links
>
>
>
>
>
>
>