--- sethkoster <
sethkoster@...> wrote:
> Hmm... It occurs to me that since I was moving the iron the very
> same problem could have happened during the re-fusing phase. Perhaps
> because the PCB is heating up and cooling down in areas as I move the
> iron around it is exacerbating this problem.
>
don't think so. copper will not heat up and cool down, less stretch while
ironing.
I am nearer to believe it's a too low temperature or board prep problem.
use the iron very hot (over 200C, 400F) and use a paper towel buffer. should
yellow slightly...
__________________________________________________
Do You Yahoo!?
Tired of spam? Yahoo! Mail has the best spam protection around
http://mail.yahoo.com