On Sat, 15 Jul 2006 21:54:03 +0200, Steve <
alienrelics@...> wrote:
> The park pad -should- always be moist, if it weren't then the heads
> would tend to dry and clog.
> If it is full, then there is something else wrong. Didn't you put a
> bulk ink system on this? The tanks may be sitting too high, or filled
> incorrectly. If not a bulk ink system, you may have either filled
> incorrectly or haven't gotten 100% sealed on the ink fill holes.
> Steve Greenfield
I have put spongeless carts on this, not a CIS.
The silicone stoppers are very likely airtight...
What could have happened is that i didn't raise the park station the
identically same amount as the head, would this cause this?
I'd assume the spring under the pad would prevent any problems there...
The spongless carts would be an obvious place to seek fault with, but i
believe they are fairly standard items.
Also, i had all the ink leak out of the cart, twice (=each time i
refilled) with the old sponged carts...
Do i need to observe something when filling those carts?
ST