>Using Shellac as a coating may not be good when SMD is involved but
>is fine for single sided through hole boards.
Just about any spray could work for single sided through hole boards
provided it was applied ∗∗after∗∗ soldering. I used to use Phenolic
boards, Cool-Amp (silver coating) and Krylon clear spray, here is an
example;
http://www.pbase.com/eldata/image/63450959The Cool-Amp wasn't necessary but the silver coating looked better
than bare copper. Why would you want to apply the Shellac before
soldering for single sided through hole boards?
--- In
Homebrew_PCBs@yahoogroups.com, "warrenbrayshaw"
<warrenbrayshaw@...> wrote:
>