i have made great board like this using the jet
printphoto multiproject-photopaper 60 sheets is 14
bucks at wally world just set the print as dark as
posible and clean the board well let the board soake
in hot hot water till it peels off dont pull it will
come loose on it's own pin holes can also come from
uneven ironing and contamenents on the board
good luck
--- Stefan Trethan <
stefan_trethan@...> wrote:
> hi
>
> i'm trying to plot directly to pcb for a time now
> and face a lot of problems. but yesterday i read
> again
> of the method with laser printing to paper /
> transparency and ironing it to the board.
> I have tried this some time ago when i read first of
> it and it gave very poor result.
>
> today i tried again with normal paper, the result
> was a bit better but anyways poor.
>
> I believe the toner layer which my laser printer (HP
> JL III D) is to thin.
> it also leaves pinholes on plain paper.
> The printer is quite old and the toner is a cheap
> remanufactured one.
>
>
> Has anyone here done this with a laser jet III or
> II?
> Would it help to buy the original toner?
>
>
>
> Which paper is best?
> I read everything from "kitchen baking paper" over
> normal 80gramm copier paper to the special glossy
> paper
> and ohp transparencies..
> If anyone has tried several papers please answer..
>
> Would the normal Xerox photocopiers work fine? (i
> believe digital ones are they)
>
>
> I would appreciate any hints..
>
>
> mfg
> st
>
>
>
__________________________________________________
Do you Yahoo!?
The New Yahoo! Search - Faster. Easier. Bingo
http://search.yahoo.com