On Wed, 14 Jun 2006 23:37:53 +0200, Robert Hedan
<
robert.hedan@...> wrote:
>
> The swapping of chips would be a pain though. Maybe a dual circuit with
> both chipsets, switch from one to the other manually.
> Robert
> :)
That would actually be easy, while the (swedish?) method is usually
executed with a unmodified printer and two sets of carts you could do the
same as i did and pull all the chips of the carts, solder them together in
parallel like they are in the printer, and swap the whole stack.
I reset the whole stack with the reset software for the PC (volkan linked
to the page), because i don't have full chips.
I find it much more reasonable to remove the chips from the carts and have
them at a separate location. One really doesn't want to pull the cart to
reset the chip if it isn't needed. They should do that from the start.....
ST