Archive of the former Yahoo!Groups mailing list: Homebrew PCBs
Subject: Temperature mod for GBC H300 laminator
From: Robert Hedan <robert.hedan@...>
Date: 2006-06-14
Hi,
Has anyone tried this conversion?
Frank over at Pulsar mentionned that it is possible to increase the
temperature setting of the H300 by changing the resistors. I was wondering
if anyone here has tried it and has any comments on DOs and DON'Ts. What
resistor value? Do you have to add a fan? Do you have to remove the
plastic casing?
Frank passes the PCB twice through the laminator, I have to pass mine over
12 times in order to get decent toner transfer, flipping the PCB over each
pass through.
Robert
:)
[Non-text portions of this message have been removed]