grantfair2001 wrote:
> The price for my Grade B, teflon stopcock 50 mL burette was $48.00
> Canadian, which equals AUD$55.
thats what I paid :)
>
> I will try your tentative startup procedure and see how it goes. I
> have yet to get a hydrometer but have located a Canadian source. A
> universal version Dual-Scale Hydrometer, 0.700 to 2.000 Specific
> Gravity, 0.050 Divisions, 0 to 70° Baume, 1° Division, Plain Form, is
> only C$18.00; they also have methyl orange but you have to call for a
> price, which I hope to do tomorrow.
>
> I will keep the list posted. Your continuing flow of information is
> great and I do appreciate it and your timne and effort.
>
thanks, you can use kitchen scales to measure out the copper
wire. Sometimes copper wire strands are coated with lubricants
and certain stuff. I once found a lot of floating rubbish in the
acid once it started etching, which I think was from coatings on
the wire. When you get the required mass of copper, give it soak
in a little hot dishwashing detergent or degreaser, then wet it
with some HCl and it should go pink, then give a final rinse.
Good source for scrap copper is scrap metal recycler. All the
scrap metal places I have ever visited have had a huge piles of
copper power cables. They sell it at about AUD$6/kg.
The universal hydrometer you describe is probably a bit
inaccurate for copper measurement. An error of +-0.05 is too
high. I would recommend you get a 1.200 to 1.300 +-0.002
They sell for AUD$26 here in Australia.
Of course once you have everything up and running, you might like
to make a mini float out of plastic that permanently sits in
your tank. That will determine if the solution is above or below
the 1.28 g/cm^3 level.
Adam