> Marvin wrote:
> I want to breadboard some SMD 6-pin IC's with 0.95mm
> pin spacing.
<SNIP>
> Suggestions (like suppliers, websites, etc) will be appreciated.
Free-Air wire them to dip sockets if its for protos.
I just put a photo up in
Files/Surface_Mount/Free-Air.jpg
showing it being done to adapt a SO8 to a DIP8 package.
I realise 0.95mm spacing is a tad smaller - but should be quite
achieveable with some kynar wirewrap wire.
It's not mechanically strong enough to go out into the real
world. But should survive prototype stage no problems.