Draft is usually one of two things, same amount of ink but head moves
twice as fast so may be misaligned a few 1/10ths of mm etc OR only
print every other 'pixel' so saving ink.........
Draft on my epson (900p photo, 5mm thick rear fed cd tray!) looks like
every other pixel, normal is well, normal, best is only use half of
the nozzles and print in half steps, I use it as it gives best result,
but after a few weeks of this only half the nozzles work and you have
to clean about 3 times to get the others going, which then stop after
a few prints, so you end up on 'best' forever........
Also 'transparency' on best prints all but squirts less ink out.
On 27/04/06, Robert Hedan <robert.hedan@...> wrote:
> I have no idea, it just was a suggestion if nothing else works.
>
> Robert
> :)
>
>
>
> > -----Message d'origine-----
> > De : Homebrew_PCBs@yahoogroups.com
> > [mailto:Homebrew_PCBs@yahoogroups.com] De la part de Steve
> > Envoyé : avril 27 2006 12:24
> > À : Homebrew_PCBs@yahoogroups.com
> > Objet : [Homebrew_PCBs] Re: RE : Direct inkjet resist
> > printing using MIS pigmented inks
> >
> >
> > Except that is a lower resolution, isn't it?
> >
> > I would turn color correction back on in the driver and turn
> > the sliders down to reduce the ink without reducing the resolution.
> >
> > Steve Greenfield
>
>
>
>
> Be sure to visit the group home and check for new Links, Files, and Photos:
> http://groups.yahoo.com/group/Homebrew_PCBs
>
> If Files or Photos are running short of space, post them here:
> http://groups.yahoo.com/group/Homebrew_PCBs_Archives/
> Yahoo! Groups Links
>
>
>
>
>
>
>
--
Lez
- Looking for early starwars (episode 4, original starwars)
recordings, even pirate
-
- I dont need your originals just some information about running time
- and scene cut points
-
-
- also looking for a car, silver or white, 4 doors -
- diesel with a bosch pump, abs and pas -
- aircon would be nice, and not a ford -