The only problem I see with that is getting the darn thing to back
up again. Don't know how that could be done. Then again, I am not
very good at this electronics "re-configuring" stuff ;-)
> Haven't thought about the details yet, but i would have the paper
leading
> edge detector applied directly to that table.
>
> If possible i plan to have this table engaged with the feed
rollers all
> the time - i don't see this as a sheet you feed like thick paper,
i see
> this as a flatbed printer - gantry style.
>
> If it takes some fooling of the mechainsm (sensors, taking over
control of
> motors at times), then that's what it takes...
>
> ST
>