On Tue, 25 Apr 2006 16:57:33 +0200, lcdpublishing
<
lcdpublishing@...> wrote:
> When printing the component side traces, I have to turn on mirror
>
> image. When it prints it, it mirrors the "whole page". Thus, if my
>
> design isn't exactly in the center of the "page", the solder and
>
> component sides will be shifted from each other.
That's why you make that little center mark on the edge exactly where the
mirrored result is mirrored around.
e.g. print a vertical line and print it again mirrored, the mark must be
exactly centered between the two.
ST