Hi Adam,
Thank you for the feedback. Thankfully the screws are common sizes, I
probably replace them with Delrin or nylon versions.
Denny
At 02:07 PM 03/07/2003 +1100, you wrote:
>Yes it will, but probably not fast as Ferric Chloride. I once had
>a stainless teaspoon sitting in a beaker containing cupric
>chloride etching and it etched a good part of it away over a few
>days. When its long term you need good chemical resistant
>materials. Are you close by to any titanium screw suppliers? :)
>
>You could try coating the screw and its surrounding with a
>solvent based contact adhesive.
>
>milwiron@... wrote:
>> Hey All,
>> Does anybody know the effects of the cupric chloride etchant solution on
>> stainless steel? I have a few stainless screws in my etching tank that
>> ammonium persulfate doesn't touch but I know ferric chloride will slowly
eat.
>> Thanks,
>> Denny
>>
>>
>> Be sure to visit the group home and check for new Bookmarks and files:
>> http://groups.yahoo.com/group/Homebrew_PCBs
>>
>> To unsubscribe from this group, send an email to:
>> Homebrew_PCBs-unsubscribe@yahoogroups.com
>>
>>
>>
>> Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
>>
>>
>
>
>
>
>Be sure to visit the group home and check for new Bookmarks and files:
>http://groups.yahoo.com/group/Homebrew_PCBs
>
>To unsubscribe from this group, send an email to:
>Homebrew_PCBs-unsubscribe@yahoogroups.com
>
>
>
>Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
>
>