Archive of the former Yahoo!Groups mailing list: Homebrew PCBs

----- Original Message -----
From: "patroclus04" <patroclus04@...>
To: <Homebrew_PCBs@yahoogroups.com>
Sent: Friday, April 21, 2006 10:33 PM
Subject: [Homebrew_PCBs] LaserJet 1022


>I just bought a new HP laserjet 1022, 1200x1200dpi.
> Using "transparency" option, darkest setting, and best resolution,
> using a generic transparency sheet (shiny on both sides), I get lots
> of pinholes, and some holes that are bigger. I could repair them with
> permanent pen, but I need to do some TSOP boards and I can't allow
> this results... so tiny tracks.
>
> Waht could I do? Is this normal? Any paper recomended?
> thanks!

You might get better results with the Mega Electronics LaserStar film. I
used to use tracing paper, it worked nearly as well as the LaserStar and is
much cheaper. As it is very thin it needs sticking to an ordinary sheet of
paper.

Leon

---
[This E-mail has been scanned for viruses but it is your responsibility
to maintain up to date anti virus software on the device that you are
currently using to read this email. ]