Hi Robert, that thin transparent strip is a linear encoder strip for
the servo motor. Yeah, I know, many folks in the CNC forums will
tell you it is impossible to do, but it is VERY possible. That's
the funny thing about Epson printers, they use some pretty hi-tech
stuff on their printers.
Anyway, the small DC motor moves the carriage back and forth. On the
carriage, there is a quadrature encoder pick-up device that reads
the lines on that strip. This is resolved into the positional
information to feed back into the motion control "Stuff".
It's really a neat little system - very closely mimics some of the
very high-end optional features on industrial CNC machines.
Chris
--- In
Homebrew_PCBs@yahoogroups.com, Robert Hedan
<robert.hedan@...> wrote:
>
> When you look at the printhead mechanism, there is;
>
> - a drive strap.
> - a front and rear guide rail.
> - a thin darkened transparency strip that passes between 2 'posts'
behind
> the printhead.
>
> What's that thin transparency strip used for? I figure it's for
motion
> control, but how does it work? It seems uniform grey colour, but
I think it
> must be more than that, is it magnetized film with position
markers? Or is
> it more of an optical device (my eyes can't make out lines, and I
don't want
> to touch it)?
>
> I'm looking at what would be required to lift the printhead
chariot by
> 1/16". So far I've determined that the drive strap would most
likely not
> require displacement. That darkened strip might still be within
sensor
> range, tests required. The front guide rail just requires a 1/16"
spacer on
> the 'skate'.
>
> The main obstacle is that rear guide rail, the printhead is
clipped around
> it. One possible solution is to trim the bottom of the clip 1/16"
and
> adding a 1/16" shim at the top of the clip. I haven't taken the
chariot
> apart yet, but the more I look at it, the more I think it would be
possible
> to modify this printer to accurately process 1/16" PCB.
>
> Robert
> :)
>
>
>
> [Non-text portions of this message have been removed]
>