Ok, I've found only one thing that could remotely look like a vacuum tube.
Night is falling and it's difficult to light the guts of a printer properly,
so I've used what I could and left the images in large format for better
clarity.
http://www.xavierkamial.com/images/C84%20021%20front.jpgThis is from the front of the printer, looking where the chariot normally
resides. I powered on the printer and shut it off while the chariot was
taking a stroll to the left.
http://www.xavierkamial.com/images/C84%20013%20middle.jpgThat is taken from the back side of the printer.
http://www.xavierkamial.com/images/C84%20014%20rear.jpgAnd that one follows the tube towards the rear of the printer. It goes
under that white felt pad.
At this juncture (<--- I always wanted to use that word) I'm scared to tug
at that tube. It appears to be snug in its position. I don't know how to
easily get clear access to that cylinder where it is attached at the front,
and I'm scared to mess up that rear pad as well.
Resuming trying to clean the head, I have exactly the types of wipes
mentionned on that site...
Robert
:(
-----Message d'origine-----
De :
Homebrew_PCBs@yahoogroups.com [mailto:
Homebrew_PCBs@yahoogroups.com] De
la part de Stefan Trethan
Envoyé : avril 17 2006 19:27
À :
Homebrew_PCBs@yahoogroups.comObjet : Re: [Homebrew_PCBs] RE : Epson Stylus C84 (was: Re: Inkjet ?)
Do not despair, check the vacuum tubing first of all, if it is well seated
and not clogged.
...
Everything you do will help me greatly because this model is a likely
candidate for me. If you are not able to clean the head i would not want
to risk the same problem, so thanks for giving it your best effort.
ST