--- In
Homebrew_PCBs@yahoogroups.com, "derekhawkins" <eldata@...> wrote:
>
> >Caveat: if you do this, then make sure you check "use black ink only"
> >in the printer driver.
>
> You may not want to do this with some models. It limits the resolution
> to draft or something of the sort. It shouldn't be necessary either if
> the CAD output is set to black.
The printer driver may decide to use a mix of color and black ink for
the edges. That is how it gets improved grey tones. But if you let it
run out of color (as the post I was replying to) then you may end up
with funky trace edges.
Of course, there's nothing stopping you from putting the same black
ink in all cartridges. You can even feed it from the same bottle if
you are putting a CIS on it.
Steve Greenfield