On Sun, 16 Apr 2006 17:20:39 +0200, lcdpublishing
<
lcdpublishing@...> wrote:
> Well, not really. Right now you cut the PCB material to size then
>
> transfer & etch.
>
>
> Rather, you have your "leading" or "reference" edge cut straight and
>
> you mark the center point on that edge. You then print one side,
>
> flip, print opposite side. Now the artwork is square to that same
>
> edge and aligned from face to face.
>
>
> Etch the board, then trim the rest to size.
>
>
> I believe that will work out okay.
At least one got it! fantastic...
ST