That is fantastic! I have got to give it a go here too. Earlier it
was mentioned that you have to use an acidic etchant as opposed to a
base etchant, is ferric chloride base or acidic?
--- In
Homebrew_PCBs@yahoogroups.com, "Stefan Trethan"
<stefan_trethan@...> wrote:
>
> WOW!
>
> If you were a girl i would probably ask you to marry me by now! ;-)
>
> I'll have to get some of that ink!
>
> By the way, the photo section reduces image resolution sometimes,
so if
> you have it larger than 480 x 271 please upload to files section.
Only the
> moderator and owner of the photo can see full resolution in the
photos
> section.
>
>
> ST
>
>
> On Fri, 14 Apr 2006 07:28:23 +0200, Volkan Sahin <vsahin@...>
> wrote:
>
> > Hi Again,
> >
> > I could not able to stop myself and decided to make a
> >
> > test pattern. I put the scanned images under
> >
> > photo/volkan's folder. All scanned images are 1 to 1.
> >
> > It is really promising and no magic. I believe that
> >
> > with this process, everyone can get similar results. I
> >
> > don't know whether 1 mil line is really a 1 mil line
> >
> > or not, but I drew it as 1 mil. I measured the
> >
> > conductivity of each line except 1 mil and 2 mil
> >
> > lines, all of them are conducting. Now, for me it is
> >
> > time to modify the printer or buy another one just for
> >
> > PCB.
> >
> >
> > Volkan.
>