On Thu, 13 Apr 2006 15:54:09 +0200, derekhawkins <
eldata@...> wrote:
> I may even become a convert provided two sided boards can be
>
> efficiently printed with less than .004" misalignment.
>
>
should not be that tricky, the front of page is detected via a optical
sensor, usually, and the repeatability side-to-side is usually very good
with inkjets, as long as you can feed the pcb at the right place, which
should not be hard with a flatbed conversion.
But i'm still too stumped that it worked at all to think about two sided
stuff...
ST