At 05:43 PM 2/26/02 +0000, caveteursus wrote:
>I was wondering if anyone had a better way of "printing" PCB outlines
>for reproduction.
>
>I use Ultiboard as my design, routing program. It allows saving the
>document to Adobe through Distiller. When I open the document (in
>Acrobat) and magnify it, however, it looks as if the doc has been
>saved as a somewhat rough bit-mapped file. If I just print the
>diagram to my laserjet, everything looks great.
PrintGL from Cary Ravitz. <
http://www.concentric.net/~ravitz/>
dwayne
Dwayne Reid <
dwayner@...>
Trinity Electronics Systems Ltd Edmonton, AB, CANADA
(780) 489-3199 voice (780) 487-6397 fax
Celebrating 18 years of Engineering Innovation (1984 - 2002)
.-. .-. .-. .-. .-. .-. .-. .-. .-. .-
`-' `-' `-' `-' `-' `-' `-' `-' `-'
Do NOT send unsolicited commercial email to this email address.
This message neither grants consent to receive unsolicited
commercial email nor is intended to solicit commercial email.