Hello
i disagree for solder quality, very bad work. Cold solder, not enough solder, solder joint missing (lower side of the 2K2 resistor near the tantalum capacitor, left side of the board)
need a serious "touch-up" work before leaving factory
but photo quality is perfect.
regards
Jacques
----- Original Message -----
From: derekhawkins
To: Homebrew_PCBs@yahoogroups.com
Sent: Tuesday, April 11, 2006 8:04 PM
Subject: [Homebrew_PCBs] Re: Through plating - double sided
>What brand soldering paste? And what process did you use to tin
>the board?
Search these archives on >plumber's solder paste<, discussion goes back
to around August 15, 2005.
>And what brand/model solder was it? Those joints are beautiful, no
>ugly residue from rosin.
Radio Shack, any rosin core solder should do, just use a toothbrush and
mineral spirits to clean off the residue.
--- In Homebrew_PCBs@yahoogroups.com, Robert Hedan <robert.hedan@...>
wrote:
>
[Non-text portions of this message have been removed]