Hi ?,
I've been looking in McMaster Carr. Just not familiar enough with the
parts.
It's a 12mm dia ACME thread. Pitch is about .080", which is near 2mm,
but not exact. Inch is about 12.44, so I'm not sure what it is!
I keep looking. The McMaster Carr prices are quite high!
Someone mentioned making an ACME tap from ACME threaded rod, maybe I'll
try that. With Delron or a similar material.
Another one I have is .375" and 16 TPI, but it's a little light.
Alan KM6VV
scratch_6057 wrote:
> Alan Marconett
>
> I'm still looking for flanged ACME
> bronze nuts and ACME threaded rods (to match some I have).
>
> Try McMaster-Carr @ http://www.mcmaster.com/ start with the
> word "acme" in the Find Products box then select Acme Hex Nuts
>
> This Link Might Work
> <http://www.mcmaster.com/param/asp/desc.asp?
> desc=Acme+Hex+Nuts&descid=1529&term=Acme+Hex+Nuts>
>