Archive of the former Yahoo!Groups mailing list: Homebrew PCBs

----- Original Message -----
From: "patroclus04" <patroclus04@...>
To: <Homebrew_PCBs@yahoogroups.com>
Sent: Saturday, April 08, 2006 10:45 PM
Subject: [Homebrew_PCBs] My first PCB (photo-resist).


>I just made my first PCB. I did two of them, with different expossure
> times.
>
> Two 6W blacklight tubes, 7 cm away from the PCB, trough a 0.5mm glass.
>
> First, I did 5 minutes exposure. Then, 2 minutes 30 seconds in
> metasilicate developer. It came out quite well. All shiny. But it
> seems that when I took it out of the developer, and tried to clean
> with a soft dumped paper, some of the etch-resistant tended to difuse.
> So I stoped, then washed it with lots of fresh water, and then dry it
> with some toilet paper.
>
> It came out well, but some borders not perfectly defined. So, I tried
> more expossure.
> This time 7 minutes, 30 seconds, and 2 minutes in metasilicate.
> This one came out better defined, but tracks were thiner, and a little
> section of a thin track dissapear.
>
> These are my conclusions...
> the second board was overexpossed. I should try near 5 minutes, and
> near 2 minutes in metasilicate.
>
> But I find hard to know when developing is over, because I see a light
> gray layer over the bare copper areas, and I don't know if it is
> finished or not. And don't know if I can safely clean it with a soft
> paper, or this way I can take it off!
>
> Any help about this to get better next time??

Your artwork might not be dense enough. How are you making your
transparencies?

Leon

---
[This E-mail has been scanned for viruses but it is your responsibility
to maintain up to date anti virus software on the device that you are
currently using to read this email. ]