Archive of the former Yahoo!Groups mailing list: Homebrew PCBs

----- Original Message -----
From: "Stefan Trethan" <stefan_trethan@...>
To: <Homebrew_PCBs@yahoogroups.com>
Sent: Friday, April 07, 2006 12:09 PM
Subject: Re: [Homebrew_PCBs] Photo-etch PCB with DF12 connector


> On Fri, 07 Apr 2006 12:36:52 +0200, Leon Heller
> <leon.heller@...> wrote:
>
>> That's what I do, so that the joint is nice and strong. I don't get any
>> problems.
>>
>
> I found a great increase in my satisfaction with the finished product once
> i made larger pads, which is why i suggest it to everyone.
>
>> My usual way - drag soldering with a Metcal mini-hoof tip after tacking
>> down
>> the corners, with plenty of flux. They are designed for reflow
>> soldering, of
>> course.
>
> I tried to find something similar for my ersa iron, it seems the power
> well or solder well tips are equivalent to the mini hoof. What outside
> diameter has this mini hoof approximately? The smaller solder well is
> 2.5mm wide and i think that could be a bit much?

Yes, they sound similar similar. PACE makes them, as well. The mini-hoof is
here:

http://www.okinternational.com/product_soldering/mx500smtc

so the solder well is probably closest.

I've got a micro-hoof as well, but that is for very fine leads.

The X is for the different temperature ranges.

Leon


---
[This E-mail has been scanned for viruses but it is your responsibility
to maintain up to date anti virus software on the device that you are
currently using to read this email. ]