When I started off making PCBs, I used photoresist PCBs from MG Chemicals.
I didn't need blacklight tubes for the process to work, a single ordinary
neon tube held about 7-8" over the PCB worked perfectly. I printed my
circuits onto overhead transparencies. Neons are cheaper than blacklight
and available in all sorts of sizes.
Robert
:)
-----Message d'origine-----
De :
Homebrew_PCBs@yahoogroups.com [mailto:
Homebrew_PCBs@yahoogroups.com] De
la part de Leon Heller
Envoyé : avril 6 2006 04:03
À :
Homebrew_PCBs@yahoogroups.comObjet : Re: [Homebrew_PCBs] Will this work? (my first photo-resist PCB)
It should work OK, I have a similar arrangement that works very well. My
distance between the glass and the tubes is greater (13 cm, IIRC). I would
just try it and see if it works. 6 mins would be a good starting point, but
you really need to use a test pattern and move a mask along every minute, to
get it working optimally.
Leon
---
[This E-mail has been scanned for viruses but it is your responsibility
to maintain up to date anti virus software on the device that you are
currently using to read this email. ]
Be sure to visit the group home and check for new Links, Files, and Photos:
http://groups.yahoo.com/group/Homebrew_PCBsIf Files or Photos are running short of space, post them here:
http://groups.yahoo.com/group/Homebrew_PCBs_Archives/ Yahoo! Groups Links