Archive of the former Yahoo!Groups mailing list: Homebrew PCBs

----- Original Message -----
From: "patroclus04" <patroclus04@...>
To: <Homebrew_PCBs@yahoogroups.com>
Sent: Thursday, April 06, 2006 8:54 AM
Subject: [Homebrew_PCBs] Will this work? (my first photo-resist PCB)


> Hello,
>
> I just got two 8W blacklight tubes, and have build some kind of
> exposure stand. I put the tubes on the bottom, facing up, and 7 cm
> above there is a transparent 0.5mm crystal. On top of it, it will be
> the PCB, facing down, with some weigth on it. Do you think this will work?
>
> I just find some problem with this approach:
> - No reflector, is it really necesary?
> - Maybe 7cm is too close to the blacklight tubes... I really don't
> know if it will be done in 2 minutes, or 6. But anyway, is it too close?

It should work OK, I have a similar arrangement that works very well. My
distance between the glass and the tubes is greater (13 cm, IIRC). I would
just try it and see if it works. 6 mins would be a good starting point, but
you really need to use a test pattern and move a mask along every minute, to
get it working optimally.

Leon

---
[This E-mail has been scanned for viruses but it is your responsibility
to maintain up to date anti virus software on the device that you are
currently using to read this email. ]