Hi Daryl,
--- In
Homebrew_PCBs@yahoogroups.com, LogicResearch
<logicresearch@...> wrote:
> With Eagle, how do you select a pad or object on the board you
have just
> routed and change it?
> The connections to solder components in are very small and I'd
like to make
> them bigger.
The easiest way would be to change the width of the trace. If you
want to have varying widths, use Ripup to delete the trace and Route
to reroute. Select the width you want for each segment.
> Looks like a good chunk of software if you can drive it.
> Also how do you force it to do single sided boards?
Set the preferred routing direction for the layer you don't want to
use to N/A in Autorouter setup.
Regards,
Dennis