Take a look at WinQCAD from microcad. I purchased the 500 pin version.
One neat feature is that is can layout the jumpers on the other side
of the board on single sided boards.
I've actually had board made from their Gerber files without issue.
I think it was $150.
Mike
--- In
Homebrew_PCBs@yahoogroups.com, "Leon Heller" <leon.heller@...>
wrote:
>
> ----- Original Message -----
> From: "LogicResearch" <logicresearch@...>
> To: <Homebrew_PCBs@yahoogroups.com>
> Sent: Saturday, April 01, 2006 8:20 PM
> Subject: [Homebrew_PCBs] PCB Software
>
>
> > Hi Everyone,
> >
> > I'm was about to purchase Easy-PC but just wondered if anyone can
suggest
> > a good software package at a good price that can do it all.
> >>From what I found they are either very expensive or totally
hopeless -
> >>easy-pc seemed to have good performance for cost.
> >
> >
> I used Easy-PC for 20 years or so, it's about the best of the
lower-cost
> packages.
>
> Leon
> --
> Leon Heller, G1HSM
> leon.heller@...
> http://www.geocities.com/leon_heller
>