On Mon, 13 Feb 2006 18:19:55 +0100, dl5012 <
dl5012@...> wrote:
> With transparencies, you can see the pattern and inspect it as you're
>
> ironing for problems - like some areas getting too much/little
>
> heat/pressure or smearing/spreading. I iron until I get some
>
> noticeable spreading so I know toner has been heated enough. I also
>
> like to start closing the holes on pads so I'm left with just a pilot
>
> hole - for easier drilling.
>
>
> Regards,
>
> Dennis
That sounds like a lot of spreading - how small a trace/pad/spacing can
you get this way?
ST