On Tue, 07 Feb 2006 19:49:33 +0100, adicont2 <
adicont2@...> wrote:
> A perfect board preparation is crucial for good results. I have same
>
> problem in the past and I blame my iron too. Now I spent at least 10
>
> minutes to board preparation (Scoch&Brite + Ajax + hard work).
>
> My iron seting is in 200C range. This temperature is ok for my tipe of
>
> tonner.
>
>
>
>
> Adrian
>
I wouldn't say you need to spend that much time, i just quickly sand the
board with very fine paper (so that you see marks everywhere is enough)
and then wipe it twice with a paper towel and alcohol. I don't think that
takes even half a minute. Those abrasive pads you get for preparing copper
tubing for soldering work well instead of the sanding paper too.
ST