--- In
Homebrew_PCBs@yahoogroups.com, "brewski922" <brewski@...> wrote:
>
> > As stated in my post, the problem was that both of my irons didn't
> > reach the 200C (392F) toner fusion temperature anywhere on their
> > surfaces. Given that they were two different irons of different
> > brands, I suspect that this might be a common problem.
>
> What if you bypassed the thermostat in the irons?
A post elsewhere in this forum clearly pointed out to me that my iron
measurements were grossly inaccurate. As someone else here stated
earlier, with an iron it's the _technique_ that's the potential
problem, not the heat.
Bill