I am using my PID+TC T controller, to a laminator.
result is perfect to me. And as my experience, without raising
T of original laminator, you can do proper toner transfer.
look at: my tech page
http://ca.geocities.com/microsoftwarecontrol/tmpr/tmpr.htm ----- Original Message -----
From: Codesuidae
To: Homebrew_PCBs@yahoogroups.com
Sent: Tuesday, February 07, 2006 3:03 PM
Subject: Re: [Homebrew_PCBs] Re: Toner transfer experiments and a fix for cheap, low-temp laminators
wbblair3 wrote:
> And keep in mind that the reason I purchased this particular $30
> laminator in the first place was to discover whether it worked as well
> as the previous $99 - $149 Royal model PL2000 which was listed as
> being very good for toner transfer. When it didn't, I found a
> workaround that should be applicable to all individuals who are stuck
> with a thermal laminator that doesn't work well in a toner transfer role.
Did you try your switch to increase the temperature of the laminator?
Any thoughts on how practical it is to get the temp on the laminator up
to where the oven would not be necessary?
Thanks for taking the time to report your findings and detail the
methods you used!
Dave K
Be sure to visit the group home and check for new Links, Files, and Photos:
http://groups.yahoo.com/group/Homebrew_PCBs
If Files or Photos are running short of space, post them here:
http://groups.yahoo.com/group/Homebrew_PCBs_Archives/
SPONSORED LINKS Electrical engineering degree online Electrical engineering degree Printed circuit board
Electrical engineering Electrical engineering course Electrical engineering graduate school
------------------------------------------------------------------------------
YAHOO! GROUPS LINKS
a.. Visit your group "Homebrew_PCBs" on the web.
b.. To unsubscribe from this group, send an email to:
Homebrew_PCBs-unsubscribe@yahoogroups.com
c.. Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.
------------------------------------------------------------------------------
[Non-text portions of this message have been removed]