Archive of the former Yahoo!Groups mailing list: Homebrew PCBs

----- Original Message -----
From: "microsoftwarecontrol" <microsoftwarecontrol@...>
To: <Homebrew_PCBs@yahoogroups.com>
Sent: Sunday, January 22, 2006 9:35 AM
Subject: Re: [Homebrew_PCBs] Re: PRess-n-peel blue


> you need better heat thransfer equipment.
>
>
> ----- Original Message -----
> From: Kim Currier
> To: Homebrew_PCBs@yahoogroups.com
> Sent: Saturday, January 21, 2006 10:15 PM
> Subject: Re: [Homebrew_PCBs] Re: PRess-n-peel blue
>
>
> Hi everyone. I purchased some press and peel Blue, and tried the first
> board. I was not real pleased, but I am SURE it isn't the products
fault. I
> used the iron on the TOP of the mask plastic. I noticed that the center
of
> the board was not very good, but the outside edges were distinct, and
sharp.
> I was applying pressure on the board with the iron, and used a sheet of
> paper on the top so that it would move freely.
>
> I was wondering, should i pre-heat the board BEFORE I apply the
> press-n-peel? Should I heat the board while I have it on TOP of the
pores
> and peel, or should I not press as hard as I did to make a good pattern
turn
> out on the board?
>
> Thanks in advance!!
>
> Kim
>
>
>
> Be sure to visit the group home and check for new Links, Files, and
Photos:
> http://groups.yahoo.com/group/Homebrew_PCBs
>
> If Files or Photos are running short of space, post them here:
> http://groups.yahoo.com/group/Homebrew_PCBs_Archives/
>
>
>
> SPONSORED LINKS Electrical engineering degree online Electrical
engineering degree Printed circuit board
> Electrical engineering Electrical engineering course Electrical
engineering graduate school
>
>
> --------------------------------------------------------------------------
----
> YAHOO! GROUPS LINKS
>
> a.. Visit your group "Homebrew_PCBs" on the web.
>
> b.. To unsubscribe from this group, send an email to:
> Homebrew_PCBs-unsubscribe@yahoogroups.com
>
> c.. Your use of Yahoo! Groups is subject to the Yahoo! Terms of
Service.
>
>
> --------------------------------------------------------------------------
----
>
>
>
> [Non-text portions of this message have been removed]
>
>
>
> Be sure to visit the group home and check for new Links, Files, and
Photos:
> http://groups.yahoo.com/group/Homebrew_PCBs
>
> If Files or Photos are running short of space, post them here:
> http://groups.yahoo.com/group/Homebrew_PCBs_Archives/
> Yahoo! Groups Links
>
>
>
>
>
>
>
>
> --
> No virus found in this incoming message.
> Checked by AVG Free Edition.
> Version: 7.1.375 / Virus Database: 267.14.21/236 - Release Date: 1/20/2006
>
>