--- In
Homebrew_PCBs@yahoogroups.com, Richard <metal@f...> wrote:
>
> Idaho, you would machine the end of shaft. You need to
> bore a hole to fit the OD of the collets. Then you need to
> cut a taper on the ID of the shaft-end, to fit the taper of
> the collets that you chose. Then you need to turn the OD
> to the right dia. for threading, and thread it for the cap/nut
> which holds the collet in.
>
> You may not have to make the nut itself; as you could
> probably find a replacement-nut for some tool that already
> uses those same collets.
Thank you, looks like way to much work, looks like I will be shopping
for a dremmel or a look alike.
Dave Miller