--- In
Homebrew_PCBs@yahoogroups.com, "glasspusher2001"
<glasspusher2001@y...> wrote:
>
> Hi,
>
> how do I buuild a pivoting drill press?
> I have a dremel, where can I get small bits for it?
>
> Don
Don,
I ordered a 50-piece carbide bit set for $19.95 from
Micro_Mark distributor in NJ.
http://www.micromark.com/plus shipping, just under $30 in less than a week.--item no. 82151,
sizes #80 through #12.
I see they also have a set of ten for $13.80--item no. 60310, sizes
#39 to #73.
I haven't used the bits yet. I am going to buld a pivoting drill
press like Stefan's first, so I don't break the bits easily.
After I ordered the bits, of course, I found carbide bits at a local
surplus tool distributor for a dollar each. Their selection wasn't
nearly as good as the 50 piece set, though.
Alan