--- In
Homebrew_PCBs@yahoogroups.com, "leon_heller" <leon.heller@b...>
wrote:
>
> This is a PCB I've produced with JetStar inkjet film:
>
> Files > LCDPUB > 18F2455.jpg
>
> It looks like the process I'm using with this film is reliable and
> repeatable. I don't waste a whole sheet of the film on a little board
> like this, of course; I cut a small piece and stick it to a sheet of
> ordinary A4 paper with a piece of masking tape, and put that in the
> paper feeder.
>
> The board is for experimenting with the USB function of the
> PIC18F2455. It just has an LED for output. It has the usual USB
> connector and a connector for the ICD 2 debugger/programmer.
Further to the above, it's just taken me a couple of hours to get that
rather simple board working! I eventually found that I had the ICD 2
connections reversed. I'm using a different connector than the one
I've used previously, I changed the footprint but forgot to swap the
pin numbers! 8-(
Leon