alan00463(
alan00463@...) is reported to have said:
> --- In Homebrew_PCBs@yahoogroups.com, Wayne Topa <linuxone@i...> wrote:
> >
>
> Those boards look nice, Wayne. Thanks for the photos.
> Is that Tinnit you used on the traces?
Not bad for the first try but I'm sure I can do better.
Yes I uded Tinnit.
> Did you place the whiteTRF
> artwork (component legend) all in one sheet? or did you do the shapes
> them individually? How do they look up close and personal?
I cut pieces of the WhiteTRF sightly larger then the board. It was
easy to position correctly over the copy on the paper. I did have to
tape it across the top (with a piece of Avery label and at each corner
on the last part through the printer) to keep the TRF from curling.
That was another problem with the larger board, I didn't anchor the
trailing edge corners.
THe smaller board 'would' have been perfect 'up close and personal' if
I hadn't run it through the printer twice. Even with the slight
offset it is legible. I 'thought' the second pass through the printer
was needid because the first board came out to light but I was wrong.
The first board/s TRF curled and the temp was too low (I think) when I
ran it through the laminator.
BTW I have asked Pulsar to klet me know how much the 8 in. x 15 Ft
bolt of WhiteTRF costs. I'll let you know when they answer.
Regards
Wayne