Archive of the former Yahoo!Groups mailing list: Homebrew PCBs

----- Original Message -----
From: "Leon Heller" <leon.heller@...>
To: <Homebrew_PCBs@yahoogroups.com>
Sent: Friday, December 30, 2005 10:40 AM
Subject: Re: [Homebrew_PCBs] Newbie. advice on best media for printing
artwork on .. I am in UK


> ----- Original Message -----
> From: "Gary" <questuk1@...>
> To: <Homebrew_PCBs@yahoogroups.com>
> Sent: Friday, December 30, 2005 10:32 AM
> Subject: [Homebrew_PCBs] Newbie. advice on best media for printing artwork
> on .. I am in UK
>
>
>> Hi
>>
>> I am about to start producing my own pcbs for hobbies etc.. using my
>> epson C64 inkjet.
>>
>> I would like advice on the best media to print the artwork on, from
>> what i have read, i assume its using OHP A4 film?
>>
>> What have you used with repeatable success, and if possible available
>> in the UK.
>
> I get very good results with JetStar film, available from:
>
> http://www.rapidelectronics.co.uk
>
> It's much better than OHP film.

If you use it, you need this data sheet.

http://www.megauk.com/datasheets/5215_Data_Sheet_JetStar_Standard_and_Premium_Instructions_(0504).pdf

Leon