bill afanaseff wrote:
>sorry i wasnt clear at all, i meant where you had your boards made :)
>
>
>
>
No problem, figured it might be just the quoting..
http://www.modellights.com/images/temp/pcb1.jpghttp://www.modellights.com/images/temp/pcb2.jpghttp://www.modellights.com/images/temp/pcb3.jpg A few pics to see what the $90 can get. 2.6" square, so 32 makes for
~216 sq inches total, a bit more than the 200 from the ad, of course
can't count on the extras.. Pic 3 shows one small error, the center
trace comes out at 90, should have come out at 45. Not a problem, but
unnecessarily close to the hole beside.. Slight misalignment in the
hole rows on the right in that pic is intentional, to move off a bit for
clearance. Been dealing with a water leak, so haven't even built one up
yet, but it's a shrink of a known good larger version, so should be no
real problems. Could have made some clearances a little larger, but not
much else, and had several 'last 2 days' additions, so not too bad.
Making notes for the next round of boards..
Tight two layer, would've been a royal pita to try to make 32 of these
by TT or similar at once. May get two boards next order, doubling up on
the shipping would make it an even better bargain.
Alan