The question is, does it not get printed or does it not get fused?
ST
On Thu, 15 Dec 2005 17:06:49 +0100, mycroft2152 <
mycroft2152@...>
wrote:
> I recently received some very thin pcb material. It was 0.5 oz and
>
> very flexible, (0.020"?) I could easily curve it around a 1" rod.
>
>
> I have an old Laserjet IIp+ laser printer, that I have been using
>
> for toner transfer. The LJ is old, heavy and built like a
>
> locomotive, so I thoough I would try printing directly on the pcb
>
> material. I put in an old cartidge and gave it a go.
>
>
> A 3" x 5" piece of pcb was attached to a regular sheet of paper with
>
> heat proof labels. I slightly precurved the pcb material. The pcb
>
> matereial ran through the LJ without a hitch!
>
>
> Unfortunately, the toner barely stuck to the pcb and was reprinted
>
> on the paper. I tried again after an extra cleaning step, but to no
>
> avail.
>
>
> It appeared that the toner was not fused and was still powdery. The
>
> fuser in the LJ may not have enough power to handle the 0.5 oz
>
> copper.
>
>
> So much for a good idea, back to the foil and the laminator.
>
>
> TANSTAAFL
>