On Wed, 14 Dec 2005 03:02:49 +0100, soffee83 <
soffee83@...> wrote:
> Are there any tricks, etc. to getting the whole crap aligned
>
> perpendicular to the table? I thought about maybe a rod or something
>
> in the chuck which was temporarily stuck into the table right at the
>
> drilling point. -???
>
>
> George
Put a rod or drill in the chuck and line it up visually with a right angle
set at the table. That's very precise if you look against a light. You
need to do it from at least two angles of course.
For holding the spindle, if you have no good straight section use v-clamps
or something on two points, one near the business end and one somewhere
above. That ought to be dead stable then.
I haven't found a quiet drill yet, the brushes seem to make much of it.
Better quality grinders make less noise, but still not as little as a
brushless motor.
ST