Wonderful! Where will you post the pic? I'll be interested to see how you do
it.
Can you list the parts you have in this CNC?
----- Original Message -----
From: "Alan King" <alan@...>
To: <Homebrew_PCBs@yahoogroups.com>
Sent: Tuesday, December 13, 2005 10:20 AM
Subject: [Homebrew_PCBs] My CNC
> I have about 8-10 days until my boards get back, which need some
> internal routes, so time to get my CNC back up and running and tuned
> up. Since it could stand a clean and some more mechanical fine tuning,
> I will deconstruct it and take pictures and measurements and write up a
> guide on how to assemble and align it easily and properly. $75-ish for
> the mechanics not including motors and driver, metal in basically all
> critical areas, parts all from Lowes, and only takes a drill and the
> ability to cut ends off etc, straight lines are from the metal parts not
> cuts. Haven't tweaked it to 100% in all ways, but it's pretty good
> already and I think almost anyone could get this built fairly well
> without a ton of tools or time. In fact, I think I'll get going on it
> some tonight, should have pictures within the next day or two.
>
> Alan
>
>
>
>
>
>
>
>
> Be sure to visit the group home and check for new Links, Files, and
> Photos:
> http://groups.yahoo.com/group/Homebrew_PCBs
>
> If Files or Photos are running short of space, post them here:
> http://groups.yahoo.com/group/Homebrew_PCBs_Archives/
> Yahoo! Groups Links
>
>
>
>
>
>