Well, thats the first measurement on the whole job!
the distance from the drill bit to the hinge is 37 cm
Chris
--- In Homebrew_PCBs@yahoogroups.com, JanRwl@A... wrote:
>
> In a message dated 12/12/2005 3:51:25 P.M. Central Standard Time,
> lcdpublishing@y... writes:
>
> The drilling depth (stroke) required for PCBs is less than 1/4"
which is
> fine for a pivoting press as long as the
> pivot point is back a bit from the tool center line.<<
> Yes, but what IS the distance between the pivot-axis and the
drill-axis? 30
> cm? More? Anyone "in here" have a source for fine 400
Hz "capacitor-run"
> or three-phase "aircraft instrument" motors that spin @ 24,000
RPM? I found
> one years back at a "junk shop" that was only 12,000 RPM, but it
does PCB
> drilling fine. Hadda build my OWN 400 Hz source. Hassle! But
no motor-brushes,
> sparks, "buzz", etc. Jan Rowland
>
>
>
>
> [Non-text portions of this message have been removed]
>