On Thu, 08 Dec 2005 13:54:27 +0100, lcdpublishing
<
lcdpublishing@...> wrote:
> Stefan,
>
>
> I believe that horribly stuff I have been having all the trouble with
>
> is FR4 material - this is the new stuff I got that wouldn't accept the
>
> toner transfer until I did the pre-etch. However, I was also doing
>
> toner transfer of legends on the bare expoxy side too and it wouldn't
>
> take either until I sanded it with 600 grit paper and then polished it
>
> with 0000 steel wool. After that, the toner stuck pretty good to the
>
> epoxy. This was done using a magazine page and an iron.
>
>
> Chris
I tried sanding it, but it still would not adhere as well as on the other
material.
ST