On Wed, 30 Nov 2005 12:39:40 +0100, Mike Young <
mikewhy@...>
wrote:
> "A watched board never reflows". I'll time it next time, and calibrate
> the
>
> knob. I turned off the heat as soon as all pads "popped", and let it cool
>
> undisturbed. That should be a usable profile as long as the ramp up isn't
>
> too aggressive. I'm a little nervous now, with SMD caps going onto the
> next
>
> board.
don't worry, they can take quite a beating.
If you need top reliability and stuff you need to stick to the recommended
profiles, but for homebrew stuff it is less critical.
Perhaps you have a multimeter with PC connection, or a storage scope, or a
x/y plotter, then you can record the profile.
Even so, with simple ovens you never get uniform temperature so it depends
where you measure etc...
ST