Screwdrivers are built for low-speed and high torque, the exact opposite of
what's needed for drilling small holes. It might be possible to set up a
gear drive using the hex drive, but that still leaves the problem of
coupling to the chuck.
----- Original Message -----
From: <pinoy_nyc@...>
> I bought this stand since I thought I can use my power screwdriver to
> drive
> the built in chuck, but I found out that the nose of the screwdriver is
> hex,
> which wont be able to driver the built in chuck, which has a round
> connector,
> and assume you'll be connecting a drill chuck on top of it.
>
> is there some kind of an adaptor (from hex to round) so I can use my
> power screwdriver to drive the built in chuck?...
>
> I hope you understand what I'm saying.