On Sun, 20 Nov 2005 07:49:43 +0100, cristian <
cristianbip@...>
wrote:
>
>
>> However there is something in that direction, that works now. If you use
>
>> one of those wax printers (e.g. tektronix phaser) it can print directly
>> on
>
>> thin material, and works as etch resist.
>
>
> Have you tried on a PCB?
>
> Cristian
>
>
Not me, no, but there was a very, very short page about it somewhere, and
the guy that did it was/is a member here.
I'm positive it worked, they used in as part of some electronics course or
something.
But those printers are not cheap.
ST