I am not sure about the errors, but it may be that you have a tool
bit size in the program that it too large for the traces. for
instance, if your bit size is listed as 0.1", and you have 0.1"
between chip pads, you cannot cut two lines around a pad and still
have any pad left. you certainly cannot put 2 or 3 traces between
pads either. if your bit was listed as 0.01", you could easily put a
trace between pads.
as for lineing up the boards. make a template, use the board
mounting holes, drill them exactly to size, put pins in the holes
that are a tight fit
use or put 4 more holes for verifying. one in each side, near the
edges, these could be actual thru holes for traces, or just alignment
holes. These should be done with the software controlling the
drill. Since you know their exact locations, when you flip the
board, you can posistion the drill over the holes and verify the
exact alignment.
There may be other ways, but this works for me.
Dave
--- In Homebrew_PCBs@y..., "dougfennell2000" <dfennell@m...> wrote:
> Hi all. I downloaded the deskpcb software and it seems to do a good
> job. I was wondering if anyone else has given it a spin. If you
have,
> here are a few questions that maybe you can help me with. In the
> create g-code section there are a few parameters that I can't
figure
> out: Tool # - what are the definitions of these tools? I'm also
> getting an error on that says 6 traces could not be routed. Is this
> because there is something I'm doing wrong with the initial layout,
> or perhaps my trace size? I'm using a 60deg. bit from think &
tinker
> and some 2 sided board I got from them as well. As a final
question,
> what is the best way to line up the board after you flip it over to
> cut the back side?
>
> Thanx,
>
> Doug